All-In-One POS Setup

  1. Lift and tilt the Groovv POS All-In-One’s Base so you can see the underside.
  2. Plug the Power Cable to the Power Cable Port; plug the other end into an electrical outlet.
  3. Thread the Power Cable through the Cable Holders.
  4. Plug the Ethernet Cable into the Ethernet Port. Two orange lights will glow to indicate the connection is successful.
  5. Thread the Ethernet Cable through the Cable Holders.
  6. Set the Base flat again so that the Printer and the Touchscreen are now facing you.
  7. Press and hold the Power Button. The color of its light will change from red to white.
  8. To open the Cash Drawer, use the keys to make sure it is unlocked. To open it manually, reach underneath the Base and press the Cash Drawer Manual Release Latch Be sure to keep the keys in a safe place.

  1. Thread the Micro USB Cable through the hollow center of the Stand Shaft.
  2. Decide where you want to mount the Stand. Note that this should be customer-facing.
  3. Set the Stand down so that the Micro USB Cable feeds smoothly through one of the 4 Cable Outlets at the bottom of the Stand Base.
  4. To mount the Stand, use a pencil to outline the Stand Base.
  5. Peel one side of the 3M Industrial-Strength, Double-Sided Tape and press it firmly against the underside of the Stand Base.
  6. Optionally, you can use a power drill and screws (not included) to mount the Stand.
    1. To do so, attach the Mounting Guide to the bottom of the Stand Base using household tape to keep it in place.
    2. Use a power drill to drill 4 holes through the base’s metal. These will be your pilot holes.
    3. With a pencil, mark the hole locations. Drill the holes. Then insert the screws and secure them with a screwdriver.
  7. Now that the Stand is securely mounted, slide the Companion Payment Device so that its Quick-Release Plate locks into the Tilting Device Base.
  8. Plug the smaller end of the Micro USB Cable into the the Micro USB Port on the left side of the Companion Payment Device.
  9. Plug the wider end of the Micro USB Cable into the USB Port on the right side of the Groovv All-In-One’s Base. An orange light will glow to confirm the connection is successful.
  10. Peel off the plastic display protector from the Color Display.
  11. On the top right corner of the Pin Pad, press and hold the power button for 3 seconds.
  12. A blue indicator light will glow, and the Color Display will then turn on. Wait until you see the WELCOME screen.
  13. Now you’re ready to setup the software.

2,028 total views, 3 views today

0 1